840 roll forming machine

840 roll forming machine adopts automatic control software to realize production information management. It has the characteristics of simple operation, easy maintenance and automatic operation. The color-coated boards produced by processing have novel appearance and uniform wave crests.

840 roll forming machine is strictly prohibited from working beyond the minimum closing height, that is, the minimum distance from the bottom of the upper sliding box to each side of the working surface is 290 mm, which requires the height after the upper and lower molds are closed plus the thickness of the upper and lower backing plates plus the thickness of the tile blank. This is not allowed. If it exceeds 290mm, the design should be based on this requirement when manufacturing molds to avoid machine tool accidents. Different models are customized according to customer requirements.

Debugging before application of 840 roll forming machine:

First, measure the four corners of the front and rear rows of the color steel tile press equipment from the height of the main frame to the upper end of the bottom shaft. Then, from the row to the back row, find a line to straighten and check whether the lower shaft is in one line. On a straight line, adjust the left and right sides of the lower axis to be horizontal. Find the center of the color steel tile equipment row and the last row, then tighten the lock nuts on both sides, and draw a straight line in front and back of the center of the middle wheel. After adjusting the gap between the upper and lower shafts, you can follow the Adjust the machine linearly. If the board runs to the right, pad the left corner (feeding rack), or drop to the bottom level on the right side (the upper shaft will fall with the bottom shaft at which axis it moves, and the upper shaft will fall with the bottom shaft). The color steel tile press has a reasonable structure and is easy to operate. Feeding, pressing, glue dispensing, heating, trimming, grooving and cutting to form plates. It adopts meticulous low-speed metering pump, variable frequency speed regulation and computer control to achieve accurate metering.

Technical parameters of 840 roll forming machine:

Length*width*height: 6800mm*1300mm*1200mm

Machine weight: about 2.6T

Large frame material: 250H steel

Medium plate thickness: 12mm

Forming shaft: diameter 68mm45# tempered

Forming wheel: material 45# forged and hard chrome plated

Transmission mode: 6-point sprocket, chain

Power: Host 4KW with cycloidal reducer

Number of forming rows: 13 rows

Molding speed: 8-10m/min

Pressing thickness: 0.2-0.7mm

Pressing width: 1000mm

Pumping station motor: 3KW